Recent Changes in Subaru/PFS Web retrieved at 19:25 (GMT)
ran updatemotormaps on last run: 15 09 09 17 18 13 TargetRun New map: 2015 09 03 NSTMaps V06.xml Edited pid 9 map to set first theta bins equal to...
Verified positioners in theta reverse hardstop by hand. Moved phi to intermediate position Ran several images without motion in between to measure joint angle stability...
Checked PID 9 shaft coupler and it is very firmly bonded. So the sticky spot noticed from targets last night is probably not a shaft coupler issue. Checked tension...
Electronics Failure on PID 9 Yesterday PID 9 stopped working after initially working We probed the output signal of PID 9 and saw a capacitive behaviour...
Status description Johannes was away 3 weeks. Chaz and Hrand tested system with camera to `see` reverse moves. On 8/31/15 Hrand, Thomas, Matt, Chaz...
Target Testing Debug Found evidence for non moving positioners within target tests. E.g. PID 41 in Test 15 07 28 17 35 02 TargetRun did not move 192 times even...
Electronics and MSIM Testing CAL from MSIM seems to be much slower searching for reason and checking on trustworthiness of data. Peter wants to see a...
FPGA Firmware Update Put firmware on fpga, new software on comm board. tested Cal Command low level Pos. 123 S1 resistors are broken Pos....
Second Temperature Test Cycle After the first cycle (RT 17 5 5 1 RT) we plan to walk through the temp points in the same order At 5C we used the...
Check Out Positioner Failing Phenomen Charlie, Hrand and Matt looked into the reasons why some positioners were not working during some of the cold tests....
Show
10,
20,
50,
100,
500,
1000 results per page, or
show all.
Related topics: RSS feed,
ATOM feed,
WebNotify,
site changes,
site map
This topic: Subaru/PFS
> WebChanges
Topic revision: r3 - 2006-11-15 - TWikiContributor